Fuji Xerox B9136 Safety Notes page 37

Operational Safety
The operator's product maintenance procedures are
described in the customer documentation supplied
with this product. Do not carry out any other
maintenance procedures not described in the
documentation.
This product features safety design not to allow
operators access to hazard areas. The hazard areas
are isolated from operators by covers or protectors
which require a tool to remove. To prevent electric
shock and injuries, never remove those covers and
protectors.
To avoid the risk of electric shock and a fire accident,
switch off and unplug the product promptly in the
following conditions, then contact your local Fuji
Xerox representative.
The product emits smoke or its surface is unusually

hot.
The product emits unusual noise or odor.

The power cord is cracked or worn down.

A circuit breaker, fuse or any other safety device is

activated.
Any liquid is spilled into the product.

 The product is soaked in water.
Any part of the product is damaged.

Do not insert any object into slots or openings of this
product.
Do not put any of the followings on the product:
 Liquid container such as flower vases or coffee cups
Metal parts such as staples or clips

Heavy objects

If liquid is spilled over or metal parts are slipped into
the product, it may cause electric shock or a fire
accident.
Do not use conductive paper such as origami paper,
carbonic paper or conductively-coated paper. When
paper jam occurs, it may cause short-circuit and
eventually a fire accident.
When cleaning this product, use the designated
cleaning materials exclusive to it. Other cleaning
materials may result in poor performance of the
product. Never use aerosol cleaners to avoid catching
fire and explosion.
Laser Safety
CAUTION: Any operations or adjustments not stated
in the operation manual maycause hazardous light
exposure and eventually burn injuries or loss of
eyesight.
This product has been tested and found to comply
with the Class 1 Laser Equipment requirements
defined by the international standard IEC60825-1:
2014 and has no light exposure hazard. The product
has no hazardous light emission as it features light
protection components and covers to shut in all light
beam during operation and maintenance.
WARNING
Laser Diode: Class 3R
Wave length: 780 nm
Beam divergence: θ// 15 deg, θ ⊥ 13 deg
Pulse duration: CW
Repetation rate: CW
Maximum power: 57.6m W
ROS ASSY: Class 3R
Wave length: 780 nm
Scanning area on photoreceptor: 320mm x 50μm
Distance between aperture and photoreceptor:
87mm
Pulse duration: 165μs
Repetation rate: 2.6kHz
Maximum power: 1.5m W
CAUTION
Always follow all warning instructions marked on or
supplied with this product.
To avoid the risk of burn injuries and electric shock,
never touch the area with the
"High Temperature" or "High Voltage" marks on.
Keep electrical and mechanical safety interlocks
active. Keep the safety interlocks away from magnetic
materials. Magnetic materials may accidentally
activate the product and cause injuries or electric
shock.
Safety Notes
37