Table of Contents
Advertisement
KA7174
To install KA7174, please refer to the installation diagram and procedures
below:
4
7
Note: The numbers shown in the diagram correspond to the step numbers
below.
1. Using the console cable provided, connect the local console devices
(mouse, keyboard, monitor) into the PS/2-USB console port on the rear of
the unit.
2. Using the KVM cable provided, connect its SPHD end to the unit's PC/
KVM port at the front of the unit.
3. Plug the VGA, USB and/or PS/2 connectors on the other end of the KVM
cable into the appropriate ports on the local computer.
Note: Plugging both the USB and PS/2 connectors into the computer at the
same time may cause the installation to malfunction.
Cat 5e cable to KVM Switch
1
5
Chapter 2. Hardware Setup
5
Local PC
3
2
6
2XRT-0015G
15
Advertisement
Table of Contents
