Table of Contents
Advertisement
Installation
KA7171 / KA7171AK
To install KA7171 / KA7171AK, please refer to the installation diagram and
procedures below:
6
PS/2
5
Note: The numbers shown in the diagram correspond to the step numbers
below.
1. Plug the cables from the local console devices (mouse, keyboard, monitor)
into their ports on the console section on the rear of the unit.
Note: The KA7171 rear panel is similar to the KA7171AK, except that it does
not have the (no.4) prioritized control port, (no.5) the RS-232 serial port, and
the (no.6) 5-V port.
2. Plug the appropriate connectors on the USB-PS/2 KVM cables supplied
with this unit into their ports on the KVM section on the front of the unit.
Cat 5e cable to KVM Switch
4
1
2XRT-0015G
USB-PS/2 KVM Cable Set
Chapter 2. Hardware Setup
Local PC
3
2
13
Advertisement
Table of Contents
