kozy heat KOMFORT 8K Homeowner's Manual

KO M FO RT 8 K
CO N TR OL S YS T E M
RC300 REMOTE INSTRUCTIONS
HOMEOWNER GUIDE
1.1 Introduction
We welcome you as an new owner of a Kozy Heat gas fireplace.
We have created this guide to help you better understand
your fireplace and its system. If you have any questions or
comments, we offer continual support and guidance to help
you achieve the maximum benefit and enjoyment from your
Kozy Heat gas fireplace.
The Komfor 8K Remote is a multifunction control designed to
control your pilot light, flame height, fan blower speed, and
auxiliary function (if applicable). The remote can also function
as thermostat to automatically control the temperature of the
room in which your fireplace is installed.
Refer to your unit installation and operation manual for more
information.
1.2 Setup Komfort 8K Remote
Verify (3) AAA batteries are installed with correct polarity in
the remote control battery bay. Ensure batteries are fresh and
fully charged.
1.3 Automatic Safety Turn-off
This system will execute an automatic turn OFF command after
8 hours of continuous main burner operation.
1.4 Backup Battery Operation
This appliance will operate on the backup battery pack in a
power outage. The lifespan of the backup batteries depends
on various factors, such as the quality of the batteries, number
of ignitions, etc.
Only install backup batteries in power outages only. Do not
leave batteries installed in the backup battery pack.
HUSSONG MFG. CO., INC. KOZY HEAT FIREPLACES
1.5 Control System 7 Day Time-out
If your Komfort 8K control system is set to pilot-on-demand
ignition with 7 consecutive days without ignition of the main
burner, the pilot will turn off. This is a standard safety feature of
the Komfort 8K control system.
Once you turn the pilot-on-demand on, the 7 day timer will
start. If at any time during the following 7 days your main
burner ignites, it will reset the timer back to 7 days.
See section on page 3 for more information about
1.6.7
pilot ignition selection.
How to check if your system is set to pilot-on-demand:
• The remote control screen will display the snowflake with
text PILOT icon.
To select the preferred pilot ignition:
1. Press the MENU button to activate the menu.
2. Using the UP and DOWN arrows, highlight the PILOT icon
and press SELECT.
3. Use the UP and DOWN arrows to turn the pilot-on-
demand ON or OFF, then press SELECT.
• A single beep will be emitted from the control module
indicating pilot-on-demand feature has been activated.
• A double beep will be emitted from the control module
indicating the pilot-on-demand feature has been
deactivated.
1