Replacing The Orifices; Adjusting The Gas Valves - Bosch NGMP058UC Installation Instructions Manual

en-us Conversion to LP gas
IMPORTANT: Attach the metallic sticker included with
6.
the conversion kit to the bottom of the appliance as
shown. This sticker provides notice that the appliance
has been converted for use with LP gas. It should be lo-
cated near the appliance rating plate.
→ "Rating plate location", Page 16
If you change the type of gas back to natural gas at a
7.
later point, remove the sticker.
5.2 Replacing the orifices
Remove all burner grates, burner caps and burner
1.
bases.
Replace the orifices with a 7 mm socket wrench. See
2.
burner chart → Page 15 .
Normal burner with one orifice
14
Dual-flame burner, first orifice
Dual-flame burner, second orifice
It is important to make sure that the orifices do not be-
come detached during removal or fastening.
They must be properly tightened to ensure that there
are no leaks.
The primary air does not have to be adjusted.
Fasten the orifices and replace the burner caps to the
3.
corresponding burners.
Put the burner grates in place.
4.
Save the orifices removed from the appliance for future
5.
use.
5.3 Adjusting the gas valves
Turn the control knobs to position off.
1.
Carefully lift off the burner grates, remove the burner
2.
caps and the burner bases.
Pull off the control knobs.
3.
Remove the main top from the cooktop.
4.
Remove the electronics pack from the control panel.
5.
Remove the white disks from the valve stems.
6.