Replacing The Nozzles - Bosch NGMP677UC Installation Manual

Grasp the plastic button stem firmly and pull it
2.
forcefully from the metal cap. The stem snaps snugly
into an indent in the cap and may require a strong pull
to remove. (Hint: it may be helpful to gently "rock" the
plastic stem while pulling it from the metal cap.)
Spring
A
Plastic button stem
B
Gasket
C
After removing the stem from the cap, rotate the stem
3.
180° so the button end of the stem is away from the
cap and the letters "LP" on the stem are upside down
when the cap is set flat on its head. Snap the stem
back in place in this position inserting it into the indent
in the metal cap.The stem should snap into place.
Important: Attach the metallic sticker (included with
4.
this conversion kit) to the bottom of the appliance as
shown, placing it near the appliance data plate (shows
model number and information about the appliance).
This sticker provides notice that the appliance has
been converted for use with LP gas.

Replacing the Nozzles

Replacing the nozzles
Remove all burner grates, burner caps and burner
1.
bases.
To replace the nozzles, use a 7 mm socket wrench.
2.
See table. It is important to make sure that the nozzles
do not become detached during removal or fastening.
They must be properly tightened to ensure that there
are no leaks.
With these burners, there is no need to adjust the
primary air.
Fasten the nozzles and attach the burner caps to the
3.
corresponding burners. Put the burner grates in place
on the corresponding burners.
Attach the sticker indicating the new gas type close to
4.
the rating label.
Save the nozzles removed from the appliance for
future use. If you change the type of gas back to
Natural Gas at a later point, remove the sticker.
13