Conversion To Lp Gas; Converting The Pressure Regulator - Bosch NGMP058UC Installation Instructions Manual

Flame Image
Completely or mostly
yellow
Yellow tips on outer
cone
Soft blue

Conversion to LP gas

5 Conversion to LP gas
Your appliance is equipped for use with natural gas on de-
Conversion to LP gas
livery. It can be changed to LP gas supply.
The components required for conversion to LP Gas are
contained in the conversion kit included with this appli-
ance, or are available from Customer Service.
→ "Customer Service", Page 15
Only a licensed specialist is authorized to switch the appli-
ance to another gas type.
Before carrying out the conversion, turn off the electricity
and gas supply.
5.1 Converting the pressure regulator
Locate the pressure regulator on the bottom right end of
1.
the appliance.
Measure
Verify that the regulator is set for the correct fuel. Retest af-
ter adjustment.
Normal for LP gas
Normal for natural gas
Remove the hexagon shaped cap from the regulator.
2.
Make sure not to dislodge the gasket
the spring inside the regulator.
Grasp the plastic button stem
3.
fully from the metal cap
The stem snaps snugly into an indent in the cap and
may require a strong pull to remove.
It may be helpful to gently "rock" the plastic stem while
pulling it from the metal cap.
Rotate the stem 180°
4.
a The button end of the stem is away from the cap.
a The letters "LP" on the stem are upside down when the
cap is set flat on its head.
Snap the stem back in place in this position inserting it
5.
into the indent in the metal cap
Conversion to LP gas en-us
on the cap or
firmly and pull it force-
⁠ .
⁠ .
⁠ .
13