Table of Contents
Advertisement
An all-pole isolating switch must be integrated into the
permanent electrical installation according to the install-
ation regulations.
Identify the phase and neutral conductors in the
1.
socket.
The appliance may be damaged if it is not connec-
ted correctly.
Connect the hob in accordance with the connection
2.
diagram.
See the rating plate for the voltage.
Connect the wires of the mains power cable accord-
3.
ing to the colour coding:
Green/yellow = Protective conductor
‒
Blue = Neutral conductor
‒
Brown = Phase (external conductor)
‒
23.8 Installing the appliance
Slide the appliance in fully and centre it.
1.
Screw the appliance into place.
2.
For handleless kitchens with vertical bar handle
3.
strips:
Attach a suitable filling piece
‒
any sharp edges and to guarantee a safe install-
ation.
Pre-drill aluminium profiles to establish a screw
‒
connection
.
Secure the appliance using a suitable screw
‒
Note: The gap between the worktop and the appliance
must not be closed by additional battens.
Thermal insulation strips must not be fitted to the side
panels of the surround unit.
23.9 Removing the appliance
Disconnect the appliance from the power supply.
1.
Undo the fastening screws.
2.
Lift the appliance slightly and pull it out completely.
3.
Installation instructions en
in order to cover
.
33
Advertisement
Table of Contents
