Advertisement
HERSCHEL Inspire Comfort
Wall & Ceiling-mounted Infrared Heaters
ELECTRICAL EQUIPMENT:
Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist.
IMPORTANT NOTICE TO PURCHASER:
Before utilizing the product, user should determine the suitability of the product for its intended use. HERSCHEL
INFRARED LTD expressly disclaims the implied warranties and conditions of merchantability and fitness for a
particular purpose. In no case shall HERSCHEL INFRARED LTD be liable under any legal theory, including but not
limited to contract or strict liability, for any direct, indirect special, incidental or consequential damages resulting
from product use.
Original English instructions covering Inspire Comfort Heaters produced 112020 onwards.
Tested to UL 1278:2014 Ed.4+R:20Aug2018 and CSA C22.2#46:2013 Ed.9
INSTALLATION & OPERATING INSTRUCTIONS
IP44
Advertisement
Table of Contents
Related Manuals for Herschel IP44
Summary of Contents for Herschel IP44
- Page 1 INFRARED LTD expressly disclaims the implied warranties and conditions of merchantability and fitness for a particular purpose. In no case shall HERSCHEL INFRARED LTD be liable under any legal theory, including but not limited to contract or strict liability, for any direct, indirect special, incidental or consequential damages resulting from product use.
- Page 2 DO NOT touch the heater when in use. Herschel panel heaters have a surface temperature of 194 - 212°F (90 - 100°C) and prolonged contact with the heater will cause burns and injury. DO NOT use the heater if the power cord is damaged or after the heater malfunctions, or if it has been dropped or damaged in any manner.
- Page 3 Switches and other controls cannot be touched by a person in the bath or shower. If in doubt, do not install. Herschel Infrared Ltd shall not be liable for any loss, damage or injury caused or resulting from inadequate fitting or incorrect placement of heaters close to water sources.
- Page 4 120V Grounding methods Inspire Comfort heaters for use on 120 volts come with a 3-pin 120 volt plug as shown in figure ‘A’. If 2 pin sockets only are available, an adapter shown in ‘C’ must be used and the green grounding lug protruding from the bottom of the adapter must be connected to the permanent ground screw provided in the outlet box shown DO NOT in figure ‘B’.
- Page 5 For mounting the Herschel panel use the supplied mounting hardware only and install in accordance with the installation guide. Herschel Infrared Ltd cannot accept responsibility for damage, loss or injury caused by, or resulting from incorrectly installed heaters.
- Page 6 Any further warranty or claims are excluded. The warranty covers the repair or replacement of the defective product only and Herschel shall have no liability for installation costs or consequential loses however incurred.
- Page 7 Please check that your Herschel far infrared heater panel cannot be removed from the wall. Removal Screw the four distance pieces so that your Herschel far infrared heater panel can be removed from the fixing brackets and taken down from the installation site.
Need help?
Do you have a question about the IP44 and is the answer not in the manual?
Questions and answers