Hertz HMR 50 Owner's Manual page 13

SUB LPF (to set the subwoofer cut-off frequency).
Rotate VOL/SEL knob to select the desired cut-off frequency of the low pass filter.
(OFF>100Hz>80Hz>60Hz).
INVERT PHASE
Rotate VOL/SEL knob to select the phase of the signal on the output.
When the function is enable
ZONE RENAME (to select the desired name of an audio zone, to facilitate identification)
Rotate VOL/SEL knob to highlight one of the available options, press to select.
(BOW>BRIDGE>COCKPIT>FLY>GALLEY>HELM>SALOON>STATEROOM 1
STATEROOM 2>STATEROOM 3>STERN>TOWER>TRANSOM>ZONE 1).
MAX VOLUME LIMIT (to limit the maximum volume output of this zone).
Rotate VOL/SEL knob to adjust the desired Volume level limit from 0 to 40.
LEVEL CONTROL MODE.
Rotate VOL/SEL knob to highlight one of the available options:
- VARIABLE (default): the volume level of the signal output from this audio zone is variable and can
be controlled via the volume mixer ([ZONES] button).
- FIXED 4 VRMS MAX: the level of the output signal from this audio zone is fixed at 4Vrms. It will no
longer be possible to change the volume level for this zone until the "Variable" mode is selected.
- FIXED 2 VRMS MAX: the level of the output signal from this audio zone is fixed at 2Vrms.
It will no longer be possible to change the volume level for this zone until the "Variable" mode is selected.
- FIXED 1 VRMS MAX: the level of the output signal from this audio zone is fixed at 1Vrms.
It will no longer be possible to change the volume level for this zone until the "Variable" mode is selected.
- OFF: this audio zone is off. This zone will no longer play any sound until "Variable" or "Fixed" mode is selected.
ZONE 2 - ZONE 3 (ZONE 2 rca out, ZONE 3 rca out setting).
- Rotate VOL/SEL knob to highlight one of the available options, press to select.
(EQ>BALANCE >LOUDNESS>ZONE RENAME>MAX VOLUME LIMIT>LEVEL CONTROL MODE).
EQ (Equalizer Setting)
Rotate VOL/SEL knob to highlight one of the available options, press to select.
(CUSTOM>CLASS>JAZZ>ROCK>POP>FLAT).
The "CUSTOM" curve can be customized by the user:
- Rotate VOL/SEL knob and select the "CUSTOM" curve.
- Press VOL/SEL knob to select the desired frequency.
- Rotate VOL/SEL knob to vary the gain level of the selected frequency.
- Press again VOL/SEL knob to go to the following frequency.
BALANCE
Balance: rotate VOL/SEL knob to adjust the Balance between the right and left channels from R07
(full right) to L07 (full left).
LOUDNESS
Rotate VOL/SEL knob to enable
ZONE RENAME (to select the desired name of an audio zone, to facilitate identification).
Rotate VOL/SEL knob to highlight one of the available options, press to select.
(BOW>BRIDGE>COCKPIT>FLY>GALLEY>HELM>SALOON>STATEROOM 1
STATEROOM 2>STATEROOM 3>STERN>TOWER>TRANSOM>ZONE 2*).
*ZONE 3 for the ZONE 3.
MAX VOLUME LIMIT (to limit the maximum volume output of this zone).
Rotate VOL/SEL knob to adjust the desired Volume level limit from 0 to 40.
the signal phase is inverted (180°).
or disable
this function.
Owner's Manual
13