Table of Contents
Advertisement
9.
When the iron completely cool down, store it in a vertical position in a
cool and dry place.
Spray Function
This function can be used any time and it does not affect the
ironing temperature.
1.
This function can be used any time and will not affect any other
setting.
2.
Fill the water tank as described in "How To Fill the Tank with Water".
3.
Aim the nozzle to the garment.
4.
Press the Spray Button.
Note: It may be necessary to press the spray button a few times to start this
function.
Steam Function
NOTE: It is recommended to use purified or mineral water to avoid
calcification build-up.
1.
Fill the iron as described in "How To Fill the Tank with
Water".
2.
Connect the iron to a suitable mains supply outlet
3.
The LCD lights up for a second and one beep can be heard.
4.
"STANDBY" will flash on LCD.
5.
Select the temperature setting to 2-dots, 3-dots or MAX
(see How To Set Temperature)
6.
When the required temperature is reached; the "STANDBY"
will be gone and the iron will beep twice.
7.
Rotate the Variable Steam / Self-Cleaning Knob to give the
desired amount of steam.
8.
The iron is now ready to use.
9.
To switch off the appliance, depress and hold the control button for 2
seconds. The LCD will black out and "STANDBY" will flash on the LCD
display.
10. Disconnect the iron from the mains supply outlet.
11. When the iron completely cool down, store it in a vertical position in a
cool and dry place.
Note: Set the Steam Control Knob to
Burst of Steam Function
This function provides an extra amount of steam to remove stubborn
wrinkles.
1.
Fill the iron as described in the section of How To Fill the Tank with
Water.
Select the temperature to ●●●(3 dots) or "Max" setting , by pressing
2.
the control knob (See How To Set Temperature).
3.
The "Standby" will be gone when the required temperature
has been reached, the iron will then beep twice.
position after use.
PAGE 7 OF 12
Advertisement
Table of Contents
