Toshiba B-EX6T Series Quick Installation Manual page 4

Hide thumbs Also See for B-EX6T Series:

NOTES:

1. When the Head Lever is turned to FREE position, the Print Head is raised.

2. To enable printing the Head Lever must be set to the Position1 / Position2. (This ensures that the Print

Head is closed.)

There are two head pressure levels . Set the Head Lever depending on the media type:

Position Position2:Labels

Position Position1:

However, proper position may differ depending on media. For details, refer to your TOSHIBA TEC

authorised service representative.

3. Do not turn the Locking Ring counter-clockwise too far or it may come off the Supply Holder.

4. Turn the Locking Ring counter clockwise and remove the Supply Holder from the Supply Shaft.

5. Put the media on the Supply Shaft.

6. Pass the media around the Guide Shaft, then pull the media towards the front of the printer.

7. Align the projection of the Supply Holder with the groove of the Supply Shaft, and push the

Supply Holder against the media until the media is held firmly in place. This will centre the

media automatically.

Then turn the Locking Ring clockwise to secure the Supply Holder.

NOTE: Do not over-tighten the Locking Ring of the Supply Holder.