The Handy 21660 Instructions

Deck hand

P/N 21660

Handy, Division of Janco Industries, Inc. warrants to the original purchaser of this product, all parts to be free from defects

in manufacture for a period of one (1) year from date of delivery. Notice of a defective part must be received in writing at

Handy Division of Janco Industries, Inc. within one (1) year of purchase. All defective parts must be returned to Handy

Industries and which, upon our examination any parts which are defective in manufacture or workmanship, will be

replaced or put in good operating condition. This warranty does not apply to damage resulting from accident, improper

installation, repair, operation or maintenance, negligence or neglect. The cost of such replacement or repair shall be

exclusive remedy for any breach of any warranty and Handy Industries shall not be liable to any person for consequential

damage, or injury, or commercial loss resulting from any breach of warranty. Handy Industries makes no warranty or

merchantability, makes no warranty of fitness for a particular purpose and makes no other warranty expressed or implied,

including implied warranty arising from the course or dealing or usage of the trade.

600 West 2

DECK HAND

-INSTRUCTIONS -PARTS DRAWING - PARTS LIST

HANDY LIMITED WARRANTY

HANDY, DIVISION OF JANCO INDUSTRIES INC.

Ave. Sully, IA 50251 – Ph: 855-752-5446 – www.handyindustries.com

Table of Contents

Need help?

Do you have a question about the 21660 and is the answer not in the manual?

Page 1 DECK HAND P/N 21660 -INSTRUCTIONS -PARTS DRAWING - PARTS LIST HANDY LIMITED WARRANTY Handy, Division of Janco Industries, Inc. warrants to the original purchaser of this product, all parts to be free from defects in manufacture for a period of one (1) year from date of delivery. Notice of a defective part must be received in writing at Handy Division of Janco Industries, Inc.
Page 2 DECK HAND ASSEMBLY INSTRUCTIONS: 1.Remove contents from carton, and make sure all pieces are accounted for. 2. Take mount 21625 and place it on the lift top at the front of the lift, then take mount 21630 (21665 if mounting to Gruntavore Lift) and place it under the lift top. Use 6-3/8” bolts provided to bolt through the mounts securing them to the lift top.
Page 3 DECK HAND 3. Once mounts are securely bolted to lift top, take mast assembly 21600 and slide receiver tube into mount. Use (2) provided 1/2" pins to lock mast in place. One pin location is on the inside of mount 21630, the second is on the mast tube just under the winch mount.
Page 4 USER INSTRUCTIONS: 1. Load front tires of the mower or item lifting onto the wheel pads. NOTE: 500 lbs Max Weight Limit 2. Using tie down straps provided, place strap over tires and tighten until front tires are secure. 3. Place mower transmission into neutral. Disengage the parking brake. Disengage the hydro-stat if equipped.