The Handy 16000G Instructions

S.A.M. 1000 AIR LIFT

INSTRUCTIONS

Part Numbers 16000G - 16000O - 16000R - 16000B

1. Center load on table - 1000 lb. maximum.

2. Connect to 110 psi maximum shop air.

3. Keep safety bar in position at all times - except

when lowering.

4. Keep hands and tools from under carriage.

5. Do not mount table when in elevated position.

6. Do not ride vehicle onto lift.

7. Lift must be in the lowered position when moving.

8. Only trained persons should operate Air Lift.

9. The working area should be sufficiently lit.

10. Foot controller should be at least 3 feet away from

Air Lift during raising and lowering operation.

11. Recommended for indoor use only.

12. Tie-down straps must be used in conjunction with

the holes provided in the lift top.

PARTS DRAWING

PART LIST

Table of Contents

Need help?

Do you have a question about the 16000G and is the answer not in the manual?

Page 1 λ λ λ Part Numbers 16000G - 16000O - 16000R - 16000B 1. Center load on table - 1000 lb. maximum. 2. Connect to 110 psi maximum shop air. 3. Keep safety bar in position at all times - except when lowering.
Page 2 NOTE: READ ENTIRE MANUAL TO COMPLY WITH ALL SAFETY AND SERVICE PRECAUTIONS. DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS ARE FOLLOWED CAREFULLY. UNPACKING AND SET-UP 1. Open carton, then remove ramp and shipping boards. 2. CAREFULLY TURN TABLE UPRIGHT INTO OPERATING POSITION BEFORE REMOVING SHIPPING CABLE RESTRAINT FROM SCISSOR MECHANISM.
Page 3 PARTS DRAWING - PARTS LIST...
Page 4 It does not cover any cost of labor, transportation, freight, installation, misuse, abuse, or rust or failure of the air cylinder and/or foot pedal due to rust and or moisture. Also excluded in this warranty are items that were purchased for the Handy lift and installed on it at the factory such as electric motors, hand-held pendants and bearings.

16000o16000r16000b