Royal Enfield INTERCEPTOR 650 2018 Service Training Manual page 182

Cam TDC aligning plate
Insert the feeler gauge of the required

specification as mention and Adjust the valve
Tappet Screw to hold the feeler Gauge and adjust
the Valve Tappet nut to its specified tightening
torque 8 - 10 Nm. (Fig 1.3)
If improper gap found, need to adjust as per specified
gap.
Tappet Nut Adjusting Tool
Valve Clearance Specification

Intake 0.08 mm
Exhaust 0.18 mm
'RH' VALVE TAPPET CLEARANCE SETTING
To align the 'R' mark (LH side) in Camshaft, rotate

the Magneto Assly. in Anti clockwise.
Ensure the 'R' mark (LH side) in Camshaft

Horizontally inline with Cylinder Head Cover joint
face.
Lock the Cam Shaft (RH side) Slot using special tool

- Cam TDC aligning plate.
Insert
the
Feeler
Gauge
Insert the feeler gauge of the required

specification as mentioned and Adjust the valve
Tappet Screw to check by the feeler Gauge and
adjust the Valve Tappet nut to its specified
tightening torque 8 - 10 Nm.
ROYAL ENFIELD 650 TWIN SERVICE TRAINING MANUAL
Insert
the
Feeler
Gauge
181