Attach the Voltage Divider Board
Materials needed
•
•
•
Procedure
1 Use a T-20 screwdriver to remove the one or two screws, depending on MS model,
Figure 7.
2 If your MS model includes a LED, remove the LED cable from the plastic holder.
Figure 8.
G7050A - Reference Compound Introduction Valve
Voltage divider board
(Figure 1
Aluminum mounting block for voltage divider board
Two screws
(Figure 1
item 4)
attaching the sheet metal baffle to the e-module.
Remove screws from the metal baffle
Remove cable from the plastic holder
item 6)
(Figure 1
item 5)
9