Install The Gc Wiring Harness In The 9000 Gc; Install The 9000 Gc Covers - Agilent Technologies G7050A Installation And Setup Manual

Install the GC wiring harness in the 9000 GC

Materials needed
•
•
Procedure
1 Route the GC Wiring Harness through the round opening on the back of the 9000 GC just
2 Plug the male end of the GC Wiring Harness into the ALS connector PCA.
Figure 31.
3 Plug the GC Wiring Harness into the MS wiring harness. See

Install the 9000 GC covers

1 Position the GC Left Side Cover on the GC and secure using two captive screws. See
24
Screwdriver, Torx T-20
GC Wiring Harness (Figure 1
above the right end of the handle on the back of the GC.
Connecting the GC Wiring Harness to the 9000 GC
Figure 30.
item 2)
G7050A - Reference Compound Introduction Valve
GC Control harness
Figure 18 on page 15.