Installing The Heated Valve Box; Install The Valve Box - Agilent Technologies G4315A Installation Manual

Installing the Heated Valve Box

WA R N I N G

Install the valve box

6
The oven, inlet, and detector may be very hot. Before proceeding,
turn off the oven and all other heated zones and let them cool down.
Harmful gases may be present. Hydrogen (if used) can present an
explosion hazard. Before proceeding, turn off all supply gases at
their sources.
Shock hazard. Before proceeding, turn off the GC and disconnect the
power cord.
1 Install two chrome-plated screws about halfway into each of
the two nut plates as shown in
Figure 4 Install the nut plate screws
2 Inside the oven, locate the pair of T–shaped cutouts on the
left wall and match them with the two tabs on the nut plate
(see Figure 5). Slide the tabs on the nut plate into the oven
cutouts so that the screws rest on the bottom of the T. Repeat
on the right side of the oven. Tighten the screws.
Figure 4.
Installation Guide: Valve Box and Valve