Rear Panel - Boss KATANA-110 BASS Owner's Manual

Panel Descriptions

Rear Panel

11
11
AC IN jack
Connect the included power cord.
* Use only the power cord that was included with the unit.
12 KATANA-210 BASS only
SPEAKER OUT jack
Connect a speaker box. Only use speaker cable to connect the
speaker. Do not use any shielded cable designed for use with bass.
¹ If a plug is inserted in this jack, no sound will be output from the
speaker.
¹ You must use a speaker box that has an input impedance of 4Ω or
higher.
13
BALANCED OUT connector
Connect this to an external PA system or other such audio
equipment.
* Pin assignment of BALANCED OUT connector
※ 出力端子の場合
1: GND 2: HOT
3: COLD
To prevent malfunction and equipment failure, always turn
down the volume, and turn off all the units before making any
connections.
[SELECT] switch
Selects either DIRECT, PRE or POST output.
[GND LIFT] switch
Loop hum noise may occur when other external devices are
connected to the KATANA BASS. In such instances, you may be
able to mitigate the problem by switching the position of the
[GND LIFT] switch. The [GND LIFT] switch should be normally set
to OFF.
Switch Description
Pin 1 of BALANCED OUT connector is disconnected from
ON
this unit's ground.
Pin 1 of BALANCED OUT connector is connected to this
OFF
unit's ground.
14
EFX LOOP SEND/RETURN jacks
Connect an external effect device (mono).
Connect the SEND jack to the input of your external effect device,
and connect the output of your external effect device to the
RETURN jack.
6
13
12
16 17 18
15
POWER AMP IN jack
This jack directly inputs a signal to the power amp without
passing it through the preamp of the KATANA BASS. You can use it
to input sound that's been shaped by an external preamp or by a
multi-effect unit equipped with an amp simulator. If you're using
the POWER AMP IN jack, the [PANEL] button is lit green.
* Sound that is input to this jack is not affected by controls other
than the [MASTER] knob, the [POWER CONTROL] switch and the
[TWEETER] button.
* The POWER AMP IN jack and the INPUT jack cannot be used
simultaneously. If cables are connected to both, the INPUT jack
has priority.
16
Bluetooth ADAPTOR connector
Connect the Bluetooth® Audio MIDI Dual Adaptor (BT-DUAL, sold
separately) to wirelessly play back music from your mobile device
like a smartphone or tablet (hereafter "mobile device"), or to edit
the effects from a dedicated app on your mobile device (p. 10).
17
USB O port
You can use a commercially available USB 2.0 cable to record the
sound of the KATANA BASS into your computer. You can also use
dedicated software to edit the settings of the internal effects (p.
10).
You must install the USB driver when connecting the unit to
your computer.
Download the USB driver from the Roland website. For details,
refer to Readme.htm which is included in the download.
http://www.boss.info/support/
18
AUX IN jack
Here you can connect a CD player, audio player, electronic musical
instrument, or similar audio source, and listen to it while you play
your bass.
14 15
19
20