Panel Descriptions; Top Panel - Boss KATANA-110 BASS Owner's Manual

Panel Descriptions

Top Panel

1
2
1
INPUT jack
Connect your electric bass here.
2
INPUT EFX
Here you can make settings for the built-in effects installed in the
input section. For details on the effect types and settings for each
knob, refer to "Using the Effects" (p. 10).
[COMP] button/knob
Sets the comp and limiter effects.
[DRIVE] button/knob
Controls distortion-type effects.
3
AMPLIFIER
[PAD] button
Switching this on lowers the input sensitivity (
Switch this on if distortion occurs in this device's input section as
the result of using basses with high output signal levels or using
connected devices. We recommend that this be switched off for
ordinary use.
[TYPE] knob
Use this to select from one of three types: vintage, flat or modern.
[GAIN] knob
This adjusts the input gain. You can make the settings for a wide
range of sounds, from clean to overdrive.
[VOLUME] knob
Adjusts the volume of the speaker and headphones.
[SHAPE] button
Adds a different tonal character to the amp sound. Pressing the
button toggles between the three types (green/red/orange). The
effect is off when the indicator is dark.
4
BLEND
[BLEND] button
Switches the frequency band in which the dry sound is blended.
Pressing the button toggles between the three types (green/red/
orange). The effect is off when the indicator is dark.
[DRY LEVEL] knob
Adjusts the level of the dry sound.
4
3
4
10 dB).
-
5
6
5
EQUALIZER
[BASS] knob
Adjusts the sound level of the low-frequency range.
[LOW MID] button
Switches between frequencies for the low midrange sound.
Pressing the button toggles between the three types (green/red/
orange).
[LOW MID] knob
Adjusts the low-middle frequency range tone.
[HIGH MID] button
Switches between frequencies for the high midrange sound.
Pressing the button toggles between the three types (green/red/
orange).
[HIGH MID] knob
Adjusts the high-middle frequency range tone.
[TREBLE] knob
Adjusts the sound level of the high-frequency range.
6
[EFFECTS] knob
Here you can make settings for the built-in effects. For details on
the effect types and settings for each knob, refer to "Using the
Effects" (p. 10).
[FX1] button/knob
Controls effects such as wah, tremolo, and octave.
[FX2] button/knob
Controls effects of delay and reverb.
[TAP] button
Sets the delay time. When you press this button two or more
times, the delay time is set to the interval between presses.
7
TONE SETTING
Here you can store or recall sounds that you've set up on the
panel.
You can store a total of six sounds.
BANK A CH1, CH2, CH3
BANK B CH1, CH2, CH3
7
8
9 10