Rear Panel - Boss KATANA-100 Owner's Manual

Rear Panel

KATANA-50
KATANA-100, KATANA-100/212, KATANA-HEAD
10
AC IN jack
Connect the included power cord.
* Use only the power cord that was included with the unit.
11
SPEAKER OUT jack
Connect a speaker box. Only use speaker cable to connect the
speaker. Do not use any shielded cable designed for use with
guitars.
* You must use a speaker box that has an input impedance of 8Ω
or higher.
* If a plug is inserted in this jack, no sound will be output from
the KATANA's own speaker.
12
PHONES/REC OUT jack
Connect headphones here. You can obtain powerful guitar sounds
just as if you were playing through the speaker. To adjust the
volume, use the [VOLUME] knob along with the [MASTER] knob.
* If a plug is inserted in this jack, no sound will be output from
the KATANA's own speaker. This is convenient if you don't want
loud sound to be produced from the speaker, such as when
you're practicing at night.
13
AUX IN jack
Here you can connect a CD player, audio player, electronic musical
instrument, or similar audio source, and listen to it while you play
your guitar.
14
LINE OUT jack
100/HEAD only
Connect this to your PA system or recorder. You can obtain powerful
guitar amp sound just as if you were playing through the speaker.
10
10
HEAD only
Recorder, etc.
13 12
16 17
11 12 13 14 15
16 17
You can use this in conjunction with an external PA system, or to
record your performance via direct line while monitoring the sound
from the KATANA's speaker.
Adjust the output level using the [VOLUME] knob.
Since the [MASTER] knob does not affect the output, you can turn
down the [MASTER] knob so that sound is output to a connected
device without any sound being produced from the amp itself.
* To prevent malfunction and equipment failure, always turn
down the volume, and turn off all the units before making any
connections.
15
EFX LOOP SEND/RETURN jacks
100/HEAD only
Connect an external effect device (monaural).
Connect the SEND jack to the input of your external effect device,
and connect the output of your external effect device to the
RETURN jack.
USB O port
16
You can use a commercially available USB 2.0 cable to record
the sound of the KATANA into your computer. You can also use
dedicated software to edit the settings of the internal effects (p. 8).
You must install the USB driver when connecting the unit to
your computer.
Download the USB driver from the Roland website. For details, refer
to Readme.htm which is included in the download.
www.boss.info/support/
Panel Descriptions
18
5