Connecting A Footswitch - Boss KATANA-110 BASS Owner's Manual

Panel Descriptions

Connecting a Footswitch

Connecting a footswitch (sold separately: BOSS FS-6, FS-7, or
FS-5L)
Rear panel
Stereo 1/4" phone type
Stereo 1/4" phone type
or
FS-6 FS-7
RING TIP
RING
TIP
Switch Explanation
TIP Switches between CH1 and CH2.
RING Switches between BANK A and BANK B.
* The KATANA BASS are compatible with latch-type footswitches
(FS-6, FS-7, FS-5L). If you're using an FS-6 or FS-7, set the mode of A
and B to FS-5L (LATCH). Momentary-type footswitches (e.g., FS-5U)
cannot be used.
Connecting the GA-FC
Connect a stereo cable to the GA-FC jack.
* Always use a stereo cable.
* Use cables that do not contain resistors.
GA-FC
Using the GA-FC
You can switch TONE SELECT (CH1–CH3, PANEL) and DRIVE. You can
also switch EFFECTS (COMP, FX1, FX2, LOOP) on/off and TAP (tap to
input time).
8
Stereo 1/4" phone type
1/4" phone type x 2
or
FS-5L
RING TIP
Using the expression pedals
If you connect an expression pedal (sold separately: Roland EV-5,
BOSS EV-30, BOSS FV-500L, BOSS FV-500H), you can use the pedal to
vary the volume or control an effect such as WAH.
Expression Pedal
Jack Explanation
VOL/EXP1, You can adjust the volume and control an effect such
EXP2 as WAH.
* You can use dedicated software (p. 10) to assign a function of
your choice to an expression pedal connected to the VOLUME or
EXP jack.
Setting MINIMUM VOLUME of an expression pedal
With the [MINIMUM VOLUME] knob of an expression pedal, you can
set the value for when the pedal is lifted up all the way (lowest value).
[MINIMUM
VOLUME]
knob
* Use only the specified expression pedal. By connecting any other
expression pedals, you risk causing malfunction and/or damage to
the unit.
Using the GA-FC to switch the BANK
With one of the channels [CH1]–[CH3] selected, hold down the
[PANEL] switch for approximately one second.
The selected [CH1]–[CH3] switch blinks, and the bank switches
between BANK A and BANK B. When BANK B is selected, the [PANEL]
button blinks slowly.
* You can't switch banks while PANEL is selected.
GA-FC