Turning The Power On/Off; Restoring The Factory Settings - Boss KATANA-110 BASS Owner's Manual

Turning the Power On/Off

* Once everything is properly connected (p. 4–p. 7), be sure
to follow the procedure below to turn on their power. If you turn
on equipment in the wrong order, you risk causing malfunction or
equipment failure.
1. Make sure that the KATANA BASS's [MASTER] knob
and the volume of the devices connected to the
KATANA BASS are set to 0.
* Before connecting your instrument to the KATANA BASS's INPUT
jack, set the [MASTER] knob to the minimum setting (far left).
2. Turn on the KATANA BASS.
* Before turning the unit on/off, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/off. However, this is normal
and does not indicate a malfunction.
3.
Turn on the power of the devices connected to the
BALANCED OUT jack and PHONES/REC OUT jack.
4.
Adjust the volume levels for the devices.
Before switching off the power, lower the volume on each of the
devices in your system and then TURN OFF the devices in the
reverse order to which they were switched on.
If you need to turn off the power completely, first turn off the unit,
then unplug the power cord from the power outlet. Refer to "To
completely turn off power to the unit, pull out the plug from the
outlet" (p. 2).

Restoring the Factory Settings

Here's how the settings stored in the KATANA BASS can be returned
to their factory-set condition (factory reset).
1. While holding down the [PANEL] button, turn the
power on.
Each of the SETTING buttons continues blinking consecutively.
When the blinking stops, all of the KATANA BASS's settings return
to the factory-set state.
* It takes approximately 30 seconds for the factory reset to be
completed. Don't turn off the power while the factory reset is in
progress.
Panel Descriptions
9