Problem Shooting - Respekta GKE 178 NA++ N Installation & Operating Instruction

English
PROBLEM
The appliance does'
work
The temperature inside
the appliance is not
cool enough
The inside temperature
is too cold
The inner surfaces of
the appliance are wet.
The outer surfaces of
the appliance are wet.
Smell odour
The door does not
close properly
Unusual noises
fi210316
USER INSTRUCTION FRIDGE-FREEZER-COMBINATION

16. Problem shooting

Check that the appliance is connected to the mains.
Check that the plug is not faulty.
Check that the appliance is switched on.
Check the fuse
Check that the voltage for the appliance is correct
Are there any faults with the socket? For this purpose connect an other electric appliance
e.g.. a Hairdryer to the socket.
Check that there is not to much food in the appliance.
Check that the Temperature controller is set to a suitable temperature.
Check that the appliance is not placed in direct sunlight, or too near to a heating source.
Check that the ambient temperature is within the operating limits of the appliance.
Are the doors of the appliance opened frequently.
Check that you have not filled more fresh food at ones in the freezer then allowed.
Increase the temperature by adjusting the temperature to a lower (warmer) setting.
The coldest setting should only be used as a rapid cool/freeze setting minimum two
hours before a large amount of fresh food is placed in the appliance. If this is not done
the temperature the fridge compartment could fall below 0°C, as the compressor will run
continuously.
Caused by condensation - dry the inside of the appliance.
Caused by condensation - dry the outer door of the appliance carefully.
Check all the food and drinks that is in the fridge is in date and correctly packed. If it isn't
it should be removed from the appliance immediately or repacked.
Check for spillages on each shelf, rack and drawer. You may need to remove the
drawers to check that no spillages have settled underneath them.
Check the drainage pipe is not clocced or the trip tray at the back of the appliance is full.
The pipe can be cleared by pouring hot water trough, but please ensure that the
appliance is turned off, the plug is removed from the socket and a jug or bucket is on
place to catch the flow of water.
Ensure there are no obstructions preventing door closure.
Check the door compartments and shelfes are correctly in place.
Check the door seal is not warped or torn.
Check the appliance is level.
Check the appliance is on a flat level surface and stable.
Check the spacing's around the appliance and insure it is not touching other items.
Bubbling and gurgling sound: This noise is emitted as the coolant fluid flows trough
the pipes within the cooling system. This is normal.
Water flowing sound: This is the normal sound of water flowing into the drain trough
the defrosting process.
If the appliance is operating noising ( compressor noise): This is normal. This noise
indicates that the compressor is operating normally. As the compressor is being
energized, it might run a bit more noisily for a short pride of time
POSSIBLE CAUSE / SOLUTION
10
GB