Jacking Points - PREVOST Motorcoach XL Series Operator's Manual

FIGURE 89
NOTE
: Reinstall support and rail extension
assembly, then secure tire with retaining bracket
before moving vehicle.
Jack and wheel nut wrench are stored at right in
forward R.H. side baggage compartment.
FIGURE 90
Check the spare
periodically to keep it ready for use. Inflate spare
tire to the pressure of the tire which has the highest
pressure on the vehicle.
Also, make sure that retaining bracket is securely
fastened in order to prevent it from moving around
inside compartment.
13005
tire`s inflation pressure
STARTING AND STOPPING PROCEDURES
Procedure
Step 1
Stop engine, apply parking brake, take out jack and
wrench, then remove spare wheel and tire from
their compartment.
Step 2
Remove hub cap (with appropriate wrench) or
cover from wheel.
Step 3
With supplied wrench, loosen all wheel nuts to
about one (1) full turn.
NOTE:
counterclockwise on R.H. side of vehicle and
clockwise on L.H. side. For hub-mounted wheels,
turn nuts counterclockwise on both sides of
vehicle.
Step 4
Use the hydraulic jack to raise the vehicle. Raise
vehicle to the height required to remove wheel.
NOTE:
For hydraulic jack placement, refer to
"Jacking points", next in this section.
WARNING
ground; if necessary, place a board under the jack.
Do not raise the vehicle until you are sure the jack
is securely engaged.
WARNING:
equipment damage, use only the recommended

jacking points.

Passengers must not remain inside vehicle while
23012
wheel is being replaced.
Step 5
Fully unscrew the wheel nuts, then remove nuts
and wheel. install spare wheel with existing nuts,
then slightly tighten nuts in a crisscross pattern
before lowering the vehicle.
Step 6
Lower vehicle (until tire touches ground) by slowly
unscrewing the jack's hydraulic valve.
Step 7
4 - 19
For stud-mounted wheels, turn nuts
: Place jack on stable and level
To prevent personal injury and
/
or