Set Up With The Display And Adjustment Module Plicscom; Insert Display And Adjustment Module - Vega VEGASON 62 Operating Instructions Manual

Ultrasonic sensor for continuous level measurement

Hide thumbs Also See for VEGASON 62:

Table of Contents

6 Set up with the display and adjustment module PLICSCOM

Mount/dismount display

and adjustment module

Set up with the display and adjustment

module PLICSCOM

6.1

The display and adjustment module can be inserted into the sensor

and removed again at any time. It is not necessary to interrupt the

voltage supply.

Proceed as follows:

1. Unscrew the housing lid

2. Place the display and adjustment module in the desired position

on the electronics (four positions in 90° offset can be selected)

and turn to the right until it clicks into place.

3. Screw housing lid with inspection window tightly back on

Disassembly is carried out in reverse order.

The display and adjustment module is powered by the sensor, an ad-

ditional connection is not necessary.

Fig. 26: Insert display and adjustment module in the single chamber housing

Note:

If you intend to retrofit the instrument with a display and adjustment

module for continuous measured value indication, a higher lid with an

inspection glass is required.

VEGASON 62 • Two-wire 4 ... 20 mA/HART

Table of Contents