Advertisement
8
Connecting the Hydraulic
Pump
No Parts Required
Procedure
1. Install the hydraulic pump with the 4 bolts and nuts
removed in
2 Disconnecting the Hydraulic Pump and
Removing the Coupler Assembly (page
2. Tighten the 2 set screws on the hydraulic-pump hub
(Figure
1).
9
Connecting the Kit and
Engine Wire Harnesses to the
Alternator
Parts needed for this procedure:
1
Alternator wire harness
Procedure
1. Connect the kit wire harness to the alternator
15).
2).
2. Connect the alternator wire harness to the engine wire
(Figure
1. Connect the alternator wire harness to the engine wire
harness here.
3. Disconnect the purple wire with the terminal ring on
4. Connect the positive terminal ring to the positive
7
Figure 15
harness
(Figure
16).
Figure 16
the starter, and secure it with electrical tape.
terminal on the starter
(Figure
15).
Advertisement
