Advertisement
Procedure
10
11
Note: Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface, set the parking
brake, shut off the engine, and remove the key.
2. Disconnect the negative battery cable; refer to your
Operator's Manual.
2
Disconnecting the Hydraulic
Pump and Removing the
Coupler Assembly
No Parts Required
Procedure
1. Loosen the 2 set screws on the hydraulic-pump hub
(Figure
1).
1. Hydraulic-pump hub
Description
No parts required
No parts required
Figure 1
2. Set screws
Qty.
–
Connect the battery.
–
Test the alternator.
2. Remove the 4 bolts and nuts from the hydraulic pump
(Figure
2).
1. Bolt and nut
3. Separate the hydraulic pump from the coupler and
move the hydraulic pump out of the way.
Note: Retain the hardware.
4. Remove the 2 flange nuts from the hydraulic-pump
hub
(Figure
3).
1. Flange nuts
5. Remove the 2 bolts and 2 washers from the coupler
assembly
(Figure
2
Use
Figure 2
Figure 3
4).
Advertisement
