Traction lever kit for greensmaster 1018, 1021 or 1026 mower (8 pages)
Summary of Contents for Toro 133-0170
Page 1
Form No. 3401-749 Rev A Cover Kit Reelmaster ® 3550 Series 18-inch Cutting Unit with Rear Roller Brush and Groomer Model No. 133-0170 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
Page 2
Installing the Kit 6. Remove the nuts, bolts, and washers from the brush plate (Figure 1. Install the existing idler assembly to the new brush plate (Figure Figure 4 7. Remove the idler assembly from the brush plate, and discard the brush plate (Figure Figure 5 2.
Page 3
4. Remove any dirt and oil from the front cover (Figure 7. Tighten the nuts to secure the covers (Figure 10). Figure 10 Figure 8 8. Remove the bottom plug to allow for drainage (Figure 1. Wear strip 11). Note: Ensure that there is a plug in the top hole; if 5.
Need help?
Do you have a question about the 133-0170 and is the answer not in the manual?
Questions and answers