Advertisement
1. Alternator pulley
3. Apply thread-locking compound to the 2 hex socket
flat head screws (M8 x 20 mm) and torque them to 26
to 31 N∙m (19 to 23 ft-lb).
5
Installing the Coupler
Assembly
No Parts Required
Procedure
1. Apply thread-locking compound to the 2 bolts
removed in
2 Disconnecting the Hydraulic Pump and
Removing the Coupler Assembly (page
2. Install the 2 bolts and washers, and torque the bolts to
1,483 to 1,907 N∙cm (131 to 169 in-lb).
3. Install the 2 nuts removed in
Hydraulic Pump and Removing the Coupler Assembly
(page 2)
and torque the nuts to 1,483 to 1,907 N∙cm
(131 to 169 in-lb).
Figure 7
2. Hex socket flat head
screws (M8 x 20 mm)
2).
2 Disconnecting the
6
Drilling Holes for the Alternator
Bracket
Parts needed for this procedure:
1
Alternator-bracket template
Procedure
Using the alternator-bracket template, drill 2 holes (5/16
inch) into the hydraulic-pump bracket
1. Alternator-bracket
template
4
(Figure
8).
Figure 8
2. Hydraulic-pump bracket
Advertisement
