Password Problems - Epson Pollution Preventer User Manual

You have been using your hard disk drive successfully for
some time but notice a reduction in performance.
The data on the disk may have become fragmented. Back up all
your data and use a disk compaction utility to reorganize the
files on your disk.
If you cannot access data on your hard disk or you are seeing
read/ write errors, the disk may have a physical problem.
Contact your Authorized EPSON Servicer or the EPSON
Connection.

Password Problems

You have forgotten your password.
You must discharge your CMOS memory. To do this, you
need to change the setting of jumper J30 to position 3-4. See
Chapter 3 for details on changing the jumper setting.
After you have changed J30, restart your system, leave it on for
a few seconds, then turn it off again. This resets the SETUP
values to their factory defaults. Both the Supervisor and the
User passwords are disabled.
Set J30 back to position 2-3. Then turn the computer on again.
Use SETUP to set a new password, if you want one.
5-10
Troubleshooting