Camera Cabling; Connect Power; Connect Ethernet Cable - ERNITEC SX Series User Manual

2.

Camera Cabling

Please follow the instructions below to complete IP Camera installation.
2.1

Connect Power

Please refer to
the camera's PoE port and plug the other end of the cable into a PoE switch.
2.2

Connect Ethernet Cable

Use of Category 5 Ethernet cable is recommended for network connection; to
have best transmission quality, cable length shall not exceed 100 meters.
Connect one end of the Ethernet cable to the RJ-45 connector of the IP Camera,
and the other end of the cable to the network switch or PC.
Check the status of the link indicator and activity indicator LEDs; if the LEDs are
unlit, please check LAN connection.
v.1.5.0912
All manuals and user guides at all-guides.com
Section: Connectors. Alternatively, connect the Ethernet cable to
NOTE: If using PoE, make sure Power Sourcing Equipment (PSE) is in
use in the network.
NOTE: In some cases, you may need use an Ethernet crossover cable
when connecting the IP Camera directly to the PC.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
www.ernitec.com
Ernitec SX Box cameraSeries User's Manual
7