Chapter 2 Network Connection; Setting The Network Camera Over The Lan; Wiring Over The Lan - ERNITEC MicroView MVIC-O4IR-E User Manual

Chapter 2 Network Connection

Note:
 You shall acknowledge that the use of the product with Internet access might be
under network security risks. For avoidance of any network attacks and
information leakage, please strengthen your own protection. If the product does not
work properly, please contact with your dealer or the nearest service center.
 To ensure the network security of the network camera, we recommend you to have
the network camera assessed and maintained termly. You can contact us if you need
such service.
Before you start:
 If you want to set the network camera via a LAN (Local Area Network), please
refer to Section 2.1 Setting the Network Camera over the LAN.
 If you want to set the network camera via a WAN (Wide Area Network), please
refer to Section 2.2 Setting the Network Camera over the WAN.

Setting the Network Camera over the LAN

Purpose:
To view and configure the camera via a LAN, you need to connect the network camera
in the same subnet with your computer, and install the SADP or Guarding Expert
software to search and change the IP of the network camera.
Note: For the detailed introduction of SADP, please refer to Appendix 1.

Wiring over the LAN

The following figures show the two ways of cable connection of a network camera and
a computer:
Purpose:
 To test the network camera, you can directly connect the network camera to the
computer with a network cable as shown in Figure 2-1.
6