PRx Performance Build Limitless Wall-Mount Rack Assembly Instructions Manual page 6

Ledger Board Installation
Ledger board is not included. Your 2x10 ledger board should be a minimum length of 50", and long
enough to attach to at least 3 studs (for safety and security).
1. Locate studs in the area that you want to place your rack.
2. Measure from the floor to where you will be placing the bottom of the ledger board. For 95"
uprights this distance is 86 ½". For 81" uprights this distance is 72 ½".
3. Attach the ledger board to each stud, with a minimum of 2 screws per stud.
Contact customer service if
hardware other than wood
screws are needed for
mounting the ledger board.
2 SCREWS PER STUD
WARNING: SERIOUS
INJURY OR DEATH
COULD OCCUR IF
PRECAUTIONS ARE
NOT TAKEN.
1. Locate studs in the area that you want to place your rack.
6
2. Measure from the floor to where you will be placing the bottom of the ledger board. For 95" uprights this
distance is 86-1/2". For 81" uprights this distance is 72-1/2".
Ledger Board Installation
(701) 566-0452
95" Upright
86-1/2"
= 86 ½" from
(95"Upright)
floor to bottom
72-1/2"
of ledger board
(81"Upright)
81" Upright
= 72 ½" from
floor to bottom
of ledger board