Dometic CoolAir RTX1000 Operating Manual page 15

RTX1000/2000, SPX1200
I
NOTE
• When the parking cooler is in BOOST mode and switched to
standby mode, it will start the next time in AUTO mode.
• A running timer is set to 0 by switching the parking cooler in standby
mode.
• The parking cooler switches off completely after 12 hours in standby
mode to save power.
• SPX1200T, SPX1200C only: When the parking cooler is switched
to standby mode via remote control, an automatic pump cycle of 8 s
is started.
7.4 Switching off the parking cooler
➤ Press the
button for at least 3 s to switch off parking cooler.
✔ The parking cooler saves the current settings.
✔ The Power LED (fig. 2 7, page 4) goes out.
I
NOTE
• When the parking cooler is in BOOST mode and switched off, it will
start the next time in AUTO mode.
• A running timer is set to 0 by switching off the parking cooler.
• If the parking cooler is switched off while the compressor is still
operating, the fan will continue to run for 20 s to dry the evaporator,
among other things.
• SPX1200T, SPX1200C only: When the parking cooler is switched
off, an automatic pump cycle of 8 s is started.
7.5 Using menus
You can set the parking cooler to suit your requirements using the menus:
1. Press the button to browse through the menus.
2. Press the or
change the selected value.
3. Press the button to reduce the selected value.
4. Press the button to increase the selected value.
I
NOTE
If you don't press any button for more than 5 s, the display switches back
to the menu mode.
EN
button to navigate to the appropriate sub-menu or to
Using the parking cooler
15