Table of Contents
Advertisement
O P E R AT I O N
Save Data To USB
Note: This option allows you to store all of your controllers data to the included USB stick. Up to 12 data
files can be stored on the stick. File names are automatically generated as CONFIG01 - CONFIG12.
These file name cannot be changed. If changed, the controller will not recognize them when you attempt
to upload it.
1. Press the SET-UP button for two seconds to enter the main menu.
2. Turn the DIAL/ENTER dial to menu option 8 (Save Data to USB). Press the DIAL/ENTER dial to
enter
3. Using the function buttons 1-12, select the file button that you wish to save to. If you select button
#4, for example, the file will be stored on the USB stick as "CONFIG04".
Note: If you have a flashing green FUNCTION button, this means you already have data stored
in that location. So if you do not want to overwrite it, do not select a flashing green button.
Load Data From USB
Note: This option can only be used if you already have data from a WiFly NE1 controller stored on your
USB stick. Data files will appear in your computer as CONFIG01 - CONFIG12. These files cannot be
renamed. Otherwise, the controller will not recognize them.
1. Press and hold the SET-UP button for two seconds to enter the main menu.
2. Turn the DIAL/ENTER dial to menu option 9 (Load Data from USB). Press the DIAL/ENTER dial to
enter.
3. Using the FUNCTION buttons 1-12, select the file button that you wish to upload into your computer.
Note: Green flashing FUNCTION buttons indicate there is data stored there and are available to be
selected. If you select a non-flashing button, you will get a "Operation Failure!" error.
Format The USB
Note: This function should be used with caution as all data on the USB stick will be erased. It is highly
recommended that you back up all USB stick files to your computer before proceeding.
1. With the controllers power switch OFF, insert the USB stick into the controllers USB port and power
on the controller.
2. Press the SET-UP button for two seconds to enter the main menu.
3. Turn the DIAL/ENTER dial to menu option 10 (Format the USB disk). Press the DIAL/ENTER dial
to enter.
4. Turn the DIAL/ENTER dial to select "YES". Press the DIAL/ ENTER dial to execute.
Strobe Settings
This setting allows you to choose the manner in which the STROBE button functions. It allows you to
choose between Latch and Flash. Selecting Latch will make the STROBE button latch ON/OFF and
selecting Flash will make it momentary, lasting only as long as you press the hold down the button.
1. Press the SET-UP button for two seconds to enter the main menu.
2. Turn the DIAL/ENTER dial to menu option 11 (Strobe Settings). Press the DIAL/ENTER dial to enter.
3. Turn the DIAL/ENTER dial to select between "Latch" and "Flash". Press the DIAL/ENTER dial to
confirm your selection
14
Advertisement
Table of Contents
