Turning On/Off The Projector - Eiki EIP-1 Owner's Instruction Manual

3.2 Turning on/off the projector

Turning on the projector
1. Remove the lens cover.
2. Make sure the signal cables are connected.
3. Plug-in the power cord. LED indicator flashes slowly.
4. Press the Power key on the remote controller or control panel to turn on the
projector. LED indicator lights up consistently at this time.
5. The message "Warming up! Please wait." appears on the screen of the
projector. Please wait for 20 seconds, the projector will detect the input signal
source automatically.
6. If the message "No Signal!" appears on the screen, please check if the signal
source has been activated or the signal cables have been connected.
7. To have the best image performance, press "Auto/Enter" each time when you
turn on the projector.
Caution
When power is on, the projector will automatically detect if the
projector is overheated internally. If yes, the LED indicator flashes
rapidly and the fan cools down automatically after 8 seconds. The
Power key does not function under this situation.
Turning off the projector
1. Press the Power key to power off the projector lamp.
2. When you press the Power key, you'll see the message "Press Power Key
again to power off lamp". Then you can press the Power key to shutdown the
projector; or this message will disappear automatically after 5 seconds.
3. As soon as the lamp is off, the LED indicator flashes rapidly. The Power key
doesn't function at this time.
Notes: Please wait at least 120 seconds before you turn on the projector again. You
should turn on the projector only after the LED indicator flashes slowly.
4. Unplug the power cord.
Caution
To protect the lamp, please do not pull out the power cord right after the
lamp is off. Please wait at least 120 seconds when the fan stops.
8