S&A CW-5300 User Manual page 9

1. Advanced parameters adjustment case:
Order Code
Temperature
1 F0
Temperature
2 F1
Difference values
3 F2
4 F3 Way of control
Alarm for over high
5 F4
water temperature
Alarm for over low
6 F5
water temperature
Alarm for over high
7 F6
Room temperature
8 F7
The allowed highest
9 F8
water temperature
The allowed lowest
10 F9
water temperature
(1) Case 1: cooling water temperature is controlled by intelligent mode. Requiring
water temperature to be between 25℃ to 31℃. Ambient temperature keeping
constant, when the set water temperature is 3℃ lower than the ambient, the
fluctuation will not exceed ±0.5 ℃ . There will be an alert when water
temperature is 10 ℃
temperature is 30.0℃, cooling water temperature is between 27.5℃ to 26.5℃,
if ambient temperature is up to 30.5℃, water temperature will be between
28.0℃ to 27.0℃.)
(2) Case 2: cooling water temperature is controlled by constant mode. Requiring
water temperature is constant in 28℃, and the fluctuate does not exceed ±2℃.
The alarm of over high water temperature will be on when water temperature is
5℃ higher than normal, and the alarm of over low water temperature will be on
when water temperature is 10℃ lower than normal.
(3) Case 3: cooling water temperature is controlled by constant mode. Requiring
water temperature is constant in 25℃, and the fluctuate does not exceed ±1℃.
The over high water temperature will be on then water temperature is higher
than 30℃, and the alarm of over low water temperature will be on when water
temperature is lower than 10℃. (No matter what is the ambient temperature,
the cooling water temperature is constant in 24.0℃ to 26.0℃)
Value in
Item
case 1
setting
Cooling
0.5
hysteresis
10
10
45
Password
31
25
lower or higher than target. (e.g. when ambient
Value in Value in
case 2 case 3
28
-3
2.0 1.0
1 0
5
10
45
8 8
30
5
9
CW-5300 Series
T-506
Temperature
controller
Factory Setting
25 25
-2
0.8
0 1
4 10
14
15
45 45
8 8
30 30
5 20
T-506H
Temperature
controller
Factory Setting
25
-2
0.3
0
10
15
45
8
30
20