Table of Contents
Advertisement
INSTALLATION
Do not carry or hold the device by the door handle. The door handle cannot support the weight
of the appliance and could break off.
1.
Carefully push the appliance into the opening and make sure that it is centred.
2.
Open the door and fasten the appliance with the screws provided.
(a) Push the unit fully in and place it in the middle of the opening.
(b) Do not kink the connecting cable.
(c) Fasten the appliance with the screws.
(d) The gap between the worktop and the appliance must not be closed by additional strips.
Important information
Electrical connection
This appliance is equipped with a plug and may only be connected to a properly installed earthed
socket. Only a qualified electrician who observes the relevant regulations may install the power plug
or replace the connection cable. If the plug is no longer accessible after installation, an all-pole
disconnector with a contact gap of at least 3 mm must be provided on the installation side. The
installation must guarantee touch protection.
568
* 20 mm for metal coverings
8
Advertisement
Table of Contents
