Installation; Fitting Instructions - Ecostrad iQ WiFi Instruction Manual

3 | Installation

These are general-purpose instructions for fitting your element into a suitable
radiator or towel rail. Always check with the radiator manufacturer to ensure the
product is suitable for use with the element, and follow any additional installation
guidance provided with the unit. Installation must be completed by a qualified
electrician. Do not attempt installation DIY.
WARNING
– Do not attempt to operate the element before it has been
installed in a fluid-filled radiator or towel rail. Switching on the element in
an empty radiator or in open air will cause the element to cease functioning.
3 – 1 | Fitting Instructions
1. Read all safety instructions and warnings stated in the preceding
section of this manual. Failing to follow these instructions can cause
damage to life or property.
2. Identify the inlet where the element will be fitted in the radiator or towel rail.
For vertical models, the element is fitted vertically, entering at the bottom of
the right-hand vertical strut. For horizontal models, the element is fitted
horizontally, entering sideways through the lowest horizontal strut. Never fit
the element at the top of a radiator or towel rail.
3. Tilt the radiator until the fitting location is at the highest point. This prevents
any fluid escaping if your radiator is pre-filled.
Ecostrad_iQ_WiFi_Element_V1.2_19072021 7