Technical Data 8; Approved Bar And Chain Combinations 8 - Dolmar PS-34 Owner's And Safety Manual

Technical data
Single-cylinder two-stroke
Piston displacement
Cylinder bore
Piston stroke
Max. power at speed
Max. torque at speed
Idling speed
Sound Pressure Level at the operator's ear
at full load according to ANSI B 75.
Sound Pressure Level at the bystander's position
(50ft/5 m distance) according to ANSI B 75.
Ignition system
Electronic, without breaker
Spark plug
or Spark plug
Electrode gap
Fuel system
Carburetor (for Canada)
Carburetor (for USA)
(all position diaphragm carburetor
with integral fuel pump)
Fuel tank capacity
Fuel mixture
Weight
without cutting attachment
Cutting attachment
Guide bar
Cutting length
Safety saw chain (pitch) 3/8"
Drive link gauge
Chain sprocket
Chain lubrication
Oil tank capacity
Approved bar and chain combinations
"Low-kickback saw chain is a chain which has met the
kickback performance requirements of ANSI B 75.-
99 (American National Standard for Power Tools-
Gasoline-Powered Chain Saws-Safety Requirements)
when tested on the representative sample of chain saws
below 3.8. C.l.D. specifed in ANSI B 75.-99". The
approved bar and chain combinations are low kickback
chains according to ANSI B 75.-99 and also meet
the kickback requirements of CSA Z62.3-96 for chain
saws below 80 cm .
3
The chain saw PS-34 has been approved with fol-
lowing guide bar and chain combinations:
Drive link gauge .050"
Guide bar 3/8"
length Part no.
4" (35 cm) 42 035 66
6" (40 cm) 42 040 66
"There may be other replacement bar and chain combi-
nations available that also reduces the risk of injury
from kickback".
8
Saw chain 3/8"
Part no.
528 092 052
528 092 056
PS-34
2.0 cu. in (33 cm
.45" (37 mm)
.22" (3 mm)
1.3/9,000 kW/rpm
1.7/6,500 Nm/rpm
2,800 rpm
98 db(A)
73 db(A)
NGK BPMR 7A
.020" (0.5 mm)
ZAMA with limiter caps
ZAMA with limiter caps
3.0 oz. (0.37 l)
see chapter "Fuel"
0 lbs. 5 oz. (4.7 kg)
sprocket nose bar
4" (35 cm) • 6" (40 cm)
(528 092 ...)
.050"
6 teeth
fully automatic oil pump
8.8 oz. (0.25 l)
WARNING
Do not use other replacement bars and chains
unless they have been designated as meeting the
ANSI B 75.-99 (for USA) and CSA Z62.3-96
(for Canada) kickback performance requirements
on that specific powerhead, or has been designated
as "low kickback" saw chain in accordance with the
ANSI B 75.-99 (for USA) and CSA Z62.3-96
(for Canada) standard.
)
3