Dolmar PS-34 Owner's And Safety Manual page 7

Proper clothing
Clothing must be sturdy and snug-fitting, but allow
complete freedom of movement. Avoid loose-fitting
jackets, scarfs, neckties, jewelry, flared or cuffed pants,
or anything that could become entangled with the
saw or brush. Wear overalls or jeans with a reinforced
cutting resistant insert (fig. 3).
Protect your hands with gloves when handling saw and
saw chain. Heavy-duty, nonslip gloves improve your grip
and protect your hands.
3
Good footing is most important in chain saw work. Wear
sturdy boots with nonslip soles. Steel-toed safety boots
are recommended.
Proper eye protection is a must. Non-fogging, vented
goggles and a face screen is recommended. Their
use reduces the risk of eye and facial injury.
Wear an approved safety hard hat to protect your
head. Chain saw noise may damage your hearing.
Always wear noise protection equipment (ear plugs
or ear muffs) to protect your hearing.
Continual and regular users should have their hearing
checked regularly.
Wear protective helmet,
eye and ear protection
The saw
Parts of the chain saw: illustrations and description of
parts see page 7.
WARNING !
Never modify a chain saw in any way. Only attach-
ments supplied by DOLMAR or expressly appro-
ved by DOLMAR for use with the specific saw are
authorized.
WARNING !
Bow guide bars substantially increase the potential
for kickback and severe or fatal injury due to the
greater kickback zone of the bow design. Bow guide
bars are not recommended for use on DOLMAR
chain saws nor are they approved by the ANSI B
75.-99 chain saw safety standard.
The use of the saw
Transporting the chain saw
WARNING!
Always stop the engine before putting a chain saw
down or carrying it. Carrying a chain saw with the
engine running is extremely dangerous. Accidental
acceleration of the engine can cause the chain to
rotate.
Avoid touching the hot muffler.
By hand: When carrying your saw by hand, the
engine must be stopped and the saw must be in
the proper position.
The chain protection cover should be over the chain
and the guide bar must point backwards. When
carrying your saw the bar should be behind you
(fig. 4).
By vehicle: When transporting in a vehicle, keep
chain and bar covered with the chain guard. Properly
secure your saw to prevent turnover, fuel spillage
and damage to the saw. Make sure the saw is not
exposed to heat or sparks.
4
7