Setting Up Using Device Code Tables - Dish Network DuoDVR ViP 722k User Manual

Setting Up Using Device Code Tables

Set up the remote to control other devices using the device codes listed on page 137. In
the instructions below, the column on the left contains the instructions and the column on
the right provides additional information.
Instructions
1
Turn the device on.
2
Find the brand name of the device in the
tables starting on page 137.
3
Press and hold the mode button until all the
other mode buttons light up, then release
the button. The mode button flashes.
4
AUX
For mode only. Press 0 for a TV, 1 for
a VCR, or 2 for a tuner or amplifier.
5
Enter one of the three-digit device codes
from the table using the number buttons.
6
If you want to program Limited Mode, press
1. If not, skip to step 7.
7
POUND
Press (#).
8
POWER
Press to turn off the device. If the
device does not turn off, go to step 10.
9
Turn the device back on and try some other
buttons to make sure they work. If the code
works for other buttons, stop here.
10
If the code doesn't work, repeat steps 3
through 9 with another device code from
the tables.
11
If you can't find a code that works, try
Setting Up Using Device Codes Scan that
follows.
Remote Controls
Controlling Other Components
Additional Information
Use the device's front panel buttons or its remote
control.
If the brand isn't listed, see Setting Up Using Device
Codes Scan on page 78.
For example, for a TV, hold the
until all of the other mode buttons light. When you
let go, TV will flash.
AUX
If you're not programming in
step 5.
The three-digit device code is for the brand name of
your device that you found in step 2.
See Limited Mode for more information.
If you entered the code correctly, the mode button
flashes three times.
If the code works, the device should turn off.
POWER
Sometimes works when other buttons
VOLUME
don't. If in Limited Mode, try
Try every code listed for your brand until one works
for your device.
TV
mode button
mode, skip to
MUTE
or .
77