Tips; Questions - Dish Network DuoDVR ViP 722k User Manual

Chapter 10

Tips

satellite receiver is reliably in one state or the other. To use discrete power commands,
complete the following:
T
IPS
• If using a specific channel for TV2 (for example, channel 60), TV2's remote control
must be programmed with a TV2 channel before you can use RECOVER.
• Place the channel sticker on the remote TV and write down the channel you use to
watch DISH Network programming. The stickers are inside the front cover of this
guide.
• If you don't want to accidentally change channels on your TV or VCR, place the
remote control in Limited Mode, as described on page 76.
• Make sure you have a remote control antenna connected so you can use Remote
Control 2. See page 17 for instructions.
Q
UESTIONS
• My remote doesn't control my receiver or other components. What should I do?
– Ensure the remote control is in the correct mode (page 76).
– Check the batteries (page 17).
– Check the remote control address (pages 73 and 79).
– Check (page 17) or adjust (page 74) the remote control antenna.
• Why does my receiver change channels or display menus at random? Your
neighbor may have their remote control set on the same address. Change the
address on your remote control and receiver as described on page 72. If that doesn't
help, you may have to install a UHF attenuator as described on page 75.
88
2
1
SAT
Press
SAT Mode
until all mode
buttons light up
Program the
remote control
4
3
or
Press
POWER
Press VOLUME UP
for discrete power on
or press VOLUME DOWN
for discrete power off
5
Press any
button
to end this
procedure