Installing a UHF Attenuator
Unwanted UHF signals may interfere with signals from the remote control to the receiver.
To prevent such interference, you can install a 10 dB attenuator (available from many
consumer electronics parts stores). Adding this attenuator will help keep out stray UHF
signals, but it will also cut down how far away you can use the remote control.
1
Remove the remote control antenna from the
R
A
EMOTE
NTENNA
panel.
2
Attach a 10 dB attenuator to the R
input.
3
Attach the remote control antenna to the
attenuator.
input on the receiver's back
A
EMOTE
NTENNA
Remote Controls
Improving Receiver Control
75