Changing Channels; Using The Menus - Dish Network 123698 User Manual

Dish networks receiver user guide

Hide thumbs

Table Of Contents

Table of Contents

Chapter 3

Using the System

Tip: The channel

you select may

display one of

several program

information

symbols. If the

program is on a

channel that is

not part of your

subscription, the

channel will be in

red.

Page 24

Recover Button

Press the RECOVER button if you accidentally change the

channel or video input on your TV and cannot get the picture

back from your satellite receiver. When you press the

RECOVER button as described below, the remote control sends commands

to your TV to change channels or video inputs to try to get you back to

watching satellite programming. This procedure works only if you have

accidentally changed the TV channel or video input. It does not recover lost

satellite signal (See Chapter 4 - Reference for troubleshooting information).

RECOVER only works if the remote control has been set up to control the

TV and/or VCR, if connected.

Note: You may need to press the RECOVER button up to 30 times to

recover your satellite TV video.

1. Press and hold the RECOVER button until all four mode buttons light,

and then let go of the button. The SAT mode button flashes twice and

then all four mode buttons flash three times.

2. Press the RECOVER button. Wait for the TV mode button to flash

once and then all four mode buttons to flash once.

3. If you see the Important System Information screen, press the

SELECT button to close the screen. You have recovered your satellite

video.

4. If you do not see the Important System Information screen, repeat

steps 2 and 3 until you have recovered your satellite video.