Maintenance And Storage; Servicing - Procom PCTT360 Owner's Manual

TO STOP H EAT ER
1. Securely close valve on propane cylinder.
2. T u n r h e t a r e e r g l u t a r o
to the OFF position. Wait 15
minutes for heater to cool down before
handling heater.
3. Always remove heater from propane tank
after each use. Do not store heater while
attached to propane tank. Remove heater
from propane tank by turning fuel connec-
tor nut clockwise. Always store propane
tank outdoors. Never store propane tank
in an enclosed area.
M AI N T EN AN CE AN D STORAGE
1. Inspect heater before each use. Check
connections for leaks. Apply a noncor-
Bubbles forming show a leak that must be
corrected. Correct all leaks at once. Have
heater inspected at least annually by a
2. Before each use, check the soft "O" ring
"O" ring is cut, scuffed, or otherwise dam-
aged, replace it.
3. Inspect hose/regulator assembly before
each use. If hose is highly worn or cut,
replace. Use only a replacement hose
A hazardous condition may result if a heater
tioning properly. When the heater is working
properly:
• Emitter screen is glowing bright orange-red.
• Flame is burning on surface of screen and
• There is no strong disagreeable odor, eye
burning or other physical discomfort.
• There is no smoke or soot internal or ex-
ternal to heater.
8
OPERAT I ON
TO RESTART H EAT ER
1. Securely close valve on propane cylinder.
k n o b c o l k c w s i e 2. Wait 5 minutes.
3. Restart following To Start Heater proce-
dure.
4. Turn off gas at propane gas supply cylin-
der when heater is not in use.
5. When heater is to be stored, connection
between propane gas supply cylinder
and heater must be disconnected and
cylinder removed from heater and stored
out of doors and in accordance with
Chapter 5 of the standard for Storage and
6. Use compressed air to gently blow out
any dirt or debris from burner tube.
SERV I CI N G
• There are no unplanned or unexplained
- shut downs of heater.
The parts lists and exploded view show
heater as it was constructed. Do not use a
heater which is different from that shown. In
this regard, use only the hose, regulator and
supplied with heater.
IMPORTANT: For this heater, regulator must
be set as shown in
there is any uncertainty about regulator set-
ting, have it checked.
w w w.usa proc om .c om
.
, page 3. If
160220-03A