Touch Panel Display; Led Printhead - FujiFilm ApeosPro C810 Reference Manual

When replacing the Waste Toner Container, toner may spill and soil the floor. We recommend laying a

piece of paper or a sheet on the floor beforehand.
A trouble with image quality results if the Drum Cartridge is placed under a direct sunlight or intense

fluorescent light, or if the drum surface is touched and scratched.
4.2 Cleaning Main Unit
 When wiping the main unit with a wet cloth, use a soft, moistened and tightly-squeezed cloth. The
main unit may break down if the moisture remains on it.
 Do not use chemicals such as benzine or thinner. Doing so may damage the paint or coating on
plastic parts.
Outside the Main Unit
Exterior
1.
Wipe the exterior with a soft, moistened, and tightly-squeezed cloth.
When stains cannot be removed easily, wipe them lightly with the soft cloth slightly moistened with a
thin neutral detergent solution.
2.
Wipe the moisture off with a dry soft cloth.

Touch Panel Display

Wipe lightly with a dry soft cloth.
When wiping the main unit with a wet cloth, wipe it lightly with a soft, moistened and tightly-
squeezed cloth.
Important
Wiping the panel strongly may damage the panel. Wipe lightly.

LED Printhead

When you have replaced the Waste Toner Container or Drum Cartridge, clean the LED printheads in
order to prevent density and color irregularities from occurring.
1.
Confirm that the machine is not operating, and open the Front Cover.
2.
Slide out the cleaning bar from the back side of the Front
Cover to clean each LED printhead.
Orient the cleaning bar with the arrow ( ↑ ) facing down, insert
the cleaning bar until it stops, and then pull it out slowly. Clean
each LED printhead by repeating the back and forth action two
to three times.
3.
Place the cleaning bar back to its original position in the back
side of the Front Cover.
4.
Close the Front Cover.
4.2 Cleaning Main Unit
25