Table of Contents
Advertisement
Operation manual
Coating Thickness Gauge NOVOTEST TP-2020
By design and operating conditions, the device belongs to the devices to be repaired by specialized
companies or a manufacturer.
To submit the device to the service center (SC) for warranty service, the datasheet of the device
must be submitted. SC shall make a record in the datasheet about the warranty service of the device and
sends the copy to the manufacturer.
The device shall be submitted for warranty (after-warranty) repair or verification along with the
datasheet of the device. The accompanying documents shall state the contact details, phone number, and
fax of the sender, and the method and address of delivery.
The warranty repair is performed upon the presence of the filled-in datasheet.
The storage conditions of the device meet the category 1 under GOST 15150 at the ambient
temperature from +5 °C to +40 °C and relative humidity up to 80 % at the temperature of 25 °C.
The batteries shall be stored in the charged condition in a dry place. The term of storage of a fully
charged and detached battery is the following:
− not more than 1 year at the temperature from 20 °C to 35 °C;
− not more than 3 months at the temperature from - 20 °C to 45 °C.
The recommended temperature during long-term storage is from 10 °C to 30 °C.
The battery must be disposed upon the termination of a storage period.
During short-term storage and in the periods between applications, the device shall be stored in the
intended packaging container. The place of storage should be free from vapors of aggressive media
(acids, alkali) and direct sunlight. The device shall not be exposed to rapid shocks, falls or strong
vibrations.
The devices shall be placed on storage racks or in palletized in the transportation container.
For long-term storage, the device must be preserved; the electronic unit, probe, and power unit
should be put into plastic bags and placed in separate sections of the transportation case of the device.
The packed devices can be transported by any kind of carrier upon the observance of the following
requirements:
− transportation is performed in the factory container;
− no direct exposure to moisture;
− the temperature is in the range from -50 °C to +50 °C;
− humidity is less than 95 % at the temperature up to 35 °C;
− vibration is within the range from 10 to 500 Hz, the amplitude up to 0.35 mm, and acceleration
2
up to 49 m/s
;
− shocks of peak acceleration of up to 98 m/s
− the devices in the vehicle are fastened to avoid falling and mutual bumps.
To avoid the moisture buildup inside the device after transportation from the sub-zero environment
to a warm place, the device should be held in a container for 6 hours at room temperature.
The device does not contain dangerous or harmful substances that could harm public health or the
environment and are not dangerous for life, public health, and the environment upon expiration of the
service life. Due to this fact, device disposal can be done according to common waste disposal practices.
Disposal shall be done by the type of components: plastic, metal, and fastening components.
The content of precious metals in the device components (electronic boards, connectors, etc.) is very
low, so recycling is not expedient.
Page 31
4 RUNNING REPAIRS
5 STORAGE
6 TRANSPORTATION
2
;
7 DISPOSAL
RDC.OD.TP-2020.000 OM
Advertisement
Table of Contents
