Working In "Memory Card" Mode - NOVOTEST TP-2020 Operating Manual

Operation manual
Coating Thickness Gauge NOVOTEST TP-2020
− «MODE»: allows choosing the measurement mode (Current, Average).
2.3.7 Working in «MEMORY CARD» mode
The device has the memory function intended for saving the measurement results in the device
memory.
2.3.7.1 Calibration backup
When going to «Memory card» section, the device goes to the memory menu (fig. 2.18).
It is recommended to back up the calibration before calibrating the factory settings of the probe.
This is needed to resume proper calibration after incorrect settings.
2.3.7.2 Downloading of calibration backups
The saved calibrations can be downloaded from the probe memory. This function is needed to
resume calibration in case of wrong settings of the probe (fig. 2.19).
2.3.7.3 Clearing of memory card
When this clause is selected (fig. 2.20), the data saved in the archive will be cleared. The archive
will be empty after clearing SD card.
2.3.7.4 Memory condition
When the menu item «Memory state» (fig. 2.21) is selected, the table with possible number of
measurements is shown, including already saved and free for storage (fig. 2.22).
Page 17
Figure 2.17 – «SETTINGS» section
Figure 2.18 – Backing up of calibrations
Figure 2.19 – Downloading of the calibration backup
Figure 2.20 – Memory card clearance menu
RDC.OD.TP-2020.000 OM